How can I splice a bar ?

 
  • Information
  • Software
    Autodesk® Advance Concrete
  • Module
    Autodesk® Advance Concrete - Reinforcement
  • Version
    > 8.1
  • Type
    Modeling
  • Difficulty
    ***

To splice a bar, use the Break a bar command on the Advance Reinforcement toolbar.

How can I splice a bar

The lap dimension 'A' can be modified by selecting < New > from the Position drop-down list.

How can I splice a bar

New positions can be entered in the last row. The first two columns are reserved for the steel grade and the bar diameter, specific to each standard. The next three columns must be filled in with the position name (e.g., Example), the material type (e.g., Concrete) and the lap length (e.g., 2 ft 6 in).

How can I splice a bar

Notice that the Position name is now set to Example and the Lap (A) value is 2'-6".

How can I splice a bar

From the Cut definition section you may choose the connection representation type between segments (Offset, Vertical, Horizontal and Coupled). From the Break points section you may select the bar segments positioning (Run out at one end, Run out at both ends, Run out in the middle and Select on screen).

After defining the desired representation, click OK to apply.

GRAITEC GROUP 2017 At GRAITEC we take privacy seriously. Please read our privacy policy.